Hints for Hiking and Traveling with a GPS

What Is It Good For

A Global Positioning System (GPS) receiver, when properly used, will help to guide you to your destination, and will also take you back to where you started. Still, if you really want to be sure that you will not get lost, then in addition to a GPS, you will also need a decent compass, a map and, if you hike in mountainous terrain, an altimeter.

Bearing, Heading and Distance

A GPS, when set to guide you to a specific waypoint displays navigational information derived from signals received from satellites, the most important being Bearing direction from the current location to a waypoint, Heading direction in which you are traveling, both in degrees, and Distance in km or miles to a waypoint. Remember that though one of the GPS displays includes a compass rose, a GPS is not a compass. Unless you move at 10 miles per hour or faster, the Heading and speed indication given by the “compass”  display on the GPS are not reliable.  However,  the BEARING to your next waypoint as reported by the GPS is accurate independent of speed of travel.  This is the reason why you need a compass when hiking. However, some GPS units, in particular those made by Magellan, in addition to the Sun/Moon rise and set computations, superimpose on the compass rose the current position of the sun and the moon. If the sun or the moon are visible, and they are not too high above the horizon, then the Magellan type GPS will also provide you with a convenient and a fairly accurate compass display when you match the compass rose “sun/moon”  with the real sun/moon..

Magnetic Deviation

Most GPS units let you choose between True and Magnetic North. The magnetic deviation computed by your GPS is of course an approximation based on your current position. It may vary by a few degrees from the actual magnetic deviation. However, unless you know the exact magnetic deviation for your location, use the one provided by the GPS to coordinate the GPS with the compass readings.

Marking Starting and Intermediate Locations

When traveling or hiking a GPS lets you easily enter/mark coordinates of your current location usually by pressing once or twice a certain key. Always mark your starting location so that you can find your way back after the hike and also mark intermediate points.

Hiking in the Woods

When you hike under dense foliage your GPS may have difficulty locking on to satellites. In general, once a lock is achieved, it is easier to keep it, even under heavy foliage, then to reacquire the satellites under the same conditions. Thus try to keep the GPS on while hiking in dense woods. If the satellite lock is lost try to find a clearing to reacquire them.

Traveling or Hiking to a Specific Waypoint

You can either follow a route consisting of several waypoints or you can set the GPS to guide you to a specific waypoint. In either case the GPS display will show the distance to the next waypoint and the Bearing to that waypoint. Set your compass to that Bearing and follow the compass. You will not need the compass if you travel at 10 miles/hour or more the Heading indicator on the GPS is then reliable. As you walk or travel, the distance to the next waypoint should be getting smaller if it does not, than you better check your equipment. Sometimes as you follow a trail, or drive on a city street, you know that to get to a specific waypoint you will have to make, e.g., a 90 degree turn. The problem is that you dont know exactly when to turn. To find out when to turn watch the Bearing to that waypoint on your GPS and watch your current Heading (on the compass if you walk, on the GPS if you drive). As you approach your turning point the Bearing should be approximately 90 degree less than the Heading for the left turn or 90 degree more for the right turn. Of course if you straddle 360 degree mark, you will have to correct for it by adding or subtracting 360. E.g., if your Heading is 10 degrees and you expect to make a 90 degree left turn, then proceed till the Bearing indicator shows 10 90 + 360 = 280 degrees.

Accuracy

Due to the Selective Availability, a fudge factor introduced by the Defense Department, signal reflections, atmospheric phenomena, number and spatial geometry of visible satellites and the inherent precision of the GPS satellite clocks, there will always be some error in determining your location, speed and altitude from GPS readings. I find my GPS to be accurate to within 0.1 miles most of the time. However, occasionally the error can go up to 0.25 (or more) miles. Take this error into account when hiking. The altitude accuracy is specified as +/- 600 feet (95% confidence)  that is why you should also carry an altimeter.

Source: GPSInformation

Leave a Reply

Your email address will not be published. Required fields are marked *